Connections; Specifications - JVC SP-XF71 Manuel D'instructions

Connections

Connecting the Center speaker
Red
Black
Typical connection method to an amplifier
Connect the speakers to the speaker terminals of the amplifier
with the speaker cords by referring to the diagram below.
• Make sure to match the polarity (ª and ·) when
connecting the speaker cords.
• The diagram below is an example of a typical connection.
CENTER
FRONT LEFT
FRONT RIGHT
FRONT CENTER SURROUND
RIGHT LEFT RIGHT
SURROUND RIGHT
SURROUND LEFT

Specifications

Satellite speakers—SP-XF71F
Type:
Speaker unit:
Frequency range:
Impedance:
Power handling capacity:
Sound pressure level:
Dimensions: 250 mm (W) x 1 104 mm (H) x 250 mm (D)
Mass:
White
Black with
white stripe
White
Black with
white stripe
SURROUND
SPEAKERS
BACK
LEFT
Recommended to use
SP-SB101—optionally
purchased.
2-way 3-speaker Bass reflex type
(Magnetically-shielded type)
5.5 cm cone (x 2), 1.5 cm dome
90 Hz to 20 000 Hz
81 dB/W•m
3.9 kg each
Connecting the speaker system to the amplifier
Before connecting:
• Turn off the power to the amplifier before connecting the
speaker system; otherwise, the speakers may be damaged.
• The impedance of each speaker is 6 Ω.
If this does not match with the speaker impedance range indicated
on the amplifier, you cannot connect this system to the amplifier.
• The maximum power handling capacity of the SP-XF71F and
SP-XF71C is 100 W. Excessive input will result in abnormal
noise and possible damage.
• Be sure to turn down the volume level on the amplifier to prevent
unwanted noise before performing following operations:
– Turning on or off other components
– Operating the amplifier
– Tuning FM stations
– Fast-forwarding a tape
– Continuously reproducing high frequency oscillation or high
pitch electronic sounds
– Connecting or disconnecting a microphone
• When using a microphone, do not aim it at the speakers or use
it near the speakers; otherwise, the howling which occurs may
damage the speakers.
• Before replacing the cartridge, always turn off the power both
to the amplifier and to the turntable; otherwise, the clicking
noise may damage the speakers.
Speaker layout
Locate the speakers as illustrated below.
• The numbers (1 and 2) in the illustration indicate their
type numbers.
Front left
speaker
Surround left
speaker
Center speaker—SP-XF71C
Type:
Speaker unit:
Frequency range:
6 Ω
Impedance:
100 W Power handling capacity:
Sound pressure level:
Dimensions:
Mass:
– 5 –
Center
speaker
Front right
speaker
Subwoofer
Surround right
speaker
2-way 3-speaker Bass reflex type
(Magnetically-shielded type)
5.5 cm cone (x 2), 1.5 cm dome
90 Hz to 20 000 Hz
340 mm (W) x 103 mm (H) x 87 mm (D)
6 Ω
100 W
81 dB/W•m
1.1 kg