Publicité
Les langues disponibles
Les langues disponibles
Figure 10
CAUTION:
ALWAYS DUCT THE FAN TO THE OUTSIDE THROUGH A
WALL OR ROOF CAP.
SECTION 8
Finishing the Installation
1.
Reinstall the filter by fitting into the channel of the hood and pushing upwards until it is
secured in place (Figure 11).
Figure 11
2.
Install the included 8 watt LED lamp into the lamp holder by lining up the pins on the
lamp base to the socket of the lamp holder and gently turning clockwise until the lamp
snaps into place and is firmly seated in the lamp holder. Install a 4 watt maximum type
C7 (candelabra base) night light (not included) into the side lamp holder and reinstall the
lamp cover by squeezing the cover's sides and fitting them into the slots on the hood.
3.
Turn switches to the "OFF" position and restore power. Test that the light and the fan are
operating properly.
4.
If there is any vibration noise, check for the source and try to tighten fasteners or adjust
the tape to make a tighter connection or seal.
SECTION 9
Controls
Your Range Hood is equipped with two rocker style switches with one controlling the lighting and
the other controlling the exhaust fan. The light switch has three positions, Main Light ( • ), Night
°
Light (
), and OFF. The fan switch has three positions, High ( • • ), Low ( • ), and OFF (
5084459 Rev. i 11-16
Channel
SECTION 10
Maintenance
Filters
1.
Grease Filter - Included with your range hood is an aluminum grease filter that should be
washed at least once a month. The filter is dishwasher safe and should be washed in a
mild soap or detergent. Reverse the instructions in the "Finishing the Installation" section
of the instructions to remove filters. If the grease filter become damaged, replace with Air
King Model GF-07 Grease Filter.
Charcoal Odor Filter - If you have installed the optional charcoal odor filter, it cannot
2.
be washed and must be discarded and replaced when it becomes noticeably dirty, has
stopped filtering the odors, or at least once per year. Replace with Air King Model CF-07
Odor Filter.
Changing the Lamp
1.
Remove the lamp cover by squeezing in the sides. The cover is held in place by tension
against the tabs on the hood.
LED Lamp: Remove lamp by gently twisting counterclockwise to release the lamp from
the base. Installation is the reverse of removal. Replace with Air King model AK8LED40 or
a compatible GU24 8 watt LED lamp
Night Light: Unscrew night light bulb from socket and replace with a 4 watt maximum type
C7 (candelabra base) night light bulb.
Fuse
1.
To replace the fuse, turn the fuse cap located next to the wire connector counter clockwise
and pull out. Replace with only a 125-Volt fuse, 1-1/2 Amp Max. Reinstall the fuse back
into the hood (Figure 7).
Cleaning
CAUTION:
CLEANSERS, ETC., AS THEY MAY DAMAGE THE RANGE HOOD.
1.
Clean your range hood with a mild detergent, such as dishwashing liquid, and dry with a soft
cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS. Completely dry before
restoring power. NEVER IMMERSE ELECTRICAL PARTS IN WATER.
2.
The fan assembly can be vacuumed when build up (dirt, lint, etc.) accumulates over time.
The fan is permanently lubricated and does not require oiling.
CALIFORNIA RESIDENTS ONLY:
WARNING:
CHEMICALS] KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER.
WARNING:
CHEMICALS] KNOWN TO THE STATE OF CALIFORNIA TO CAUSE REPRODUCTIVE
TOXICITY.
°
).
www.airkinglimited.com
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE SERVICING THE UNIT.
DO NOT USE GASOLINE, BENZINE, THINNER, HARSH
THIS PRODUCT CAN EXPOSE YOU TO A CHEMICAL [OR
THIS PRODUCT CAN EXPOSE YOU TO A CHEMICAL [OR
4 of 12
Publicité
