Turning On The Appliance; Steam Ironing - Rotex U981EU4 Mode D'emploi

• TURNING ON THE APPLIANCE

Position the appliance on a level and stable surface.
o
o Before you connect the appliance to the mains power supply, please check whether
the data specified on the type plate corresponds to your power supply voltage, and
then set the switch (7) to "ON."
o The illuminated pilot light (5) indicates that the iron is heating up.
o Wait 4 – 5 minutes, until the pilot light goes out.
o The iron is now ready-for-use.

• STEAM IRONING

o You can steam-iron using either STEAM JETS or CONTINUOUS STEAM GENERATION.
o To iron using steam jets, press the steam button (4, Fig. C), exerting more or less
pressure to regulate the desired steam rate.
o Should you wish to use the maximum steam intensity, push the steam button down
fully. The steam flow will always remain constant, and in proportion to the pressure
you exert on the button.
o To iron with continuous steam, turn the steam regulator (2, Fig. D) clockwise as
shown. You thus obtain a uniform and continuous flow of steam, which is at its
strongest when the steam regulator is fully rotated.
o You can also increase the steam jet during continuous steam generation by pressing
the steam button (4).
o No matter whether you are ironing using the steam jet function or with continuous
steam, never turn the iron upside down, or tilt it too far forward or to the side.
o It must be emphasized that steam is also generated in the automatic mode during
short interruptions in ironing, e.g. when you are preparing the next garment to be
ironed or you briefly switch off the ROTEL STEAMIRONPROFEXTRA981EU1 and EU3.
However, if you take into consideration just how easily steam is generated manually,
it is advisable to avoid automatic steam output, and thereby save energy and steam.
o When setting down the ROTEL STEAMIRONPROFEXTRA981EU1 and EU3 there is a
risk of it slipping!
o When the water volume has completely evaporated, no more steam will be emitted.
o Caution! Before setting down the iron, always switch off the steam flow. NEVER OPEN
THE SAFETY CAP (1) DURING USE. FIRST SET THE SWITCH (7) TO "0" BEFORE OPENING
THE SAFETY CAP. NEXT, PULL THE POWER PLUG OUT OF THE SOCKET AND THEN RE-
LEASE THE PRESSURE IN THE IRON BY PRESSING THE STEAM BUTTON (4).
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
70