Leadvision Elegance Premium Guide D'installation page 9

Lower the post skirt ( K-LV-0119) over
Lower the post skirt ( K-LV-0119) over
Lower the post skirt ( K-LV-0119) over
5 5
the post sleeve (N-UH35) as shown in
the post sleeve (N-UH35) as shown in the post sleeve (N-UH35) as shown in
diagram 8.
diagram 8.
diagram 8.
Drill in the top post brackets (D-R0211)
Drill in the top post brackets (D-R0211) with
Drill in the top post brackets (D-R0211) with
with screw WJ0130 as shown in diagram 9
screw WJ0130 as shown in diagram 9. screw WJ0130 as shown in diagram 9.
Drill in the bottom post brackets ( D-R0211)
Drill in the bottom post brackets
Drill in the bottom post brackets
with screw WJ0130 as shown in diagram 10
(D-R0211) with screw WJ0130 as shown in (D-R0211) with screw WJ0130 as shown in
diagram 10.
diagram 10.
DIAGRAM 8
DIAGRAM 8
D-R0211 with
D-R0211 with
D-R0211
(
screw WJ0130
screw WJ0130
DIAGRAM 10 DIAGRAM 10
D-R0211 D-R0211 with D-R0211 with
( )
screw WJ0130 screw WJ0130
DIAGRAM 9
DIAGRAM 9
)
Cut rail (A-UR02) to the length between
Cut rail (A-UR02) to the length between Cut rail (A-UR02) to the length between
6 6
the post sleeve (N-UH35) minus 3 mm the post sleeve (N-UH35) minus 3 mm
the post sleeve (N-UH35) minus 3 mm
(0.118") on each side for inserting the
(0.118") on each side for inserting the
(0.118") on each side for inserting the
gaskets (F-R0102) as shown in diagram 11. gaskets (F-R0102) as shown in diagram 11.
gaskets (F-R0102) as shown in diagram 11.
Remember to take out galvanized insert
Remember to take out galvanized insert
Remember to take out galvanized insert
(B-LV-0209) before cutting rail (A-UR02).
(B-LV-0209) before cutting rail (A-UR02).
(B-LV-0209) before cutting rail (A-UR02). The galvanized insert (B-LV-0209) should The galvanized insert (B-LV-0209) should
be cut 6mm shorter than the rail
be cut 6mm shorter than the rail
The galvanized insert (B-LV-0209) should
(A-UR02).
(A-UR02).
be cut 6mm shorter than the rail (A-UR02).
Note: Need to leave at least 89 mm
Note: Need to leave at least 89 mm
(3.504") between the ends of the rail (3.504") between the ends of the rail
Note: Need to leave at least 89 mm
and the frst hole of each end as shown in
and the frst hole of each end as shown in
(3.504") between the ends of the rail and
diagram 12.
diagram 12.
the frst hole of each end as shown in diagram 12
DIAGRAM 11
DIAGRAM 11
MIN
89mm（ 3.5" ）
DIAGRAM 12 DIAGRAM 12
36" Hybrid Composite Railing Installation Guide |
MIN
89mm（ 3.5" ）
9
9