Publicité
Les langues disponibles
Les langues disponibles
2D Photo button: A photo is taken by pressing the button.
2P Video button: Video button: A video is recorded by pressing the video button
(the LEDs (1C) begin to blink). Pressing the button again stops the recording and
the LEDs (1C) illuminate continuously again. Only recordings that are stopped with
this button are saved.
2G Turbo button: The lowest speed is activated when the model is switched on. By
pressing the button twice, the medium level is activated and the remote control
issues two short beeps. By pressing again, the remote control issues three short
beeps for the highest speed. Pressing the button again returns to the lowest level.
Flip button: A longer vertical press (about 2 seconds) of control (2I) activates the flip
function. The next movement with control (2C) allows the model to complete a 360°
flip in the corresponding direction. In the process, ensure a safety altitude of about 2
metres and a sufficiently charged battery.
2H Warning! Technical modifications! Doubleclick on button for Headless
Mode: Headless mode supports beginners in the initial stages. Regardless of whe-
re the quadrocopter turns, the direction of flight always corresponds exactly to the
direction specified with the control for forwards/backwards and sideways move-
ment (2I). An example: If the model were to be turned 180° and flown towards
the operator, the operator would have to „convert" the forwards/backwards and
sideways movement accordingly. This is no longer necessary if headless mode is
activated, as the internal processor always converts the control directions automati-
cally. The LEDs on the model always flash briefly twice if headless mode is activa-
ted. Doubleclicking the (2H) button again deactivates the mode.
Attention: The model „notes" the forwards direction during each switch-on. This
means that the operator must not turn when controlling the model, as this would
change the concept of „forwards" and „right/left" in relation to the model. If the operator
changes position and wants to use headless mode - or if the control direction is no longer
correct due to a collision, the model must be restarted.
8A Insert a memory card: To record videos, the micro-SD memory card must be
inserted. The card must be inserted carefully in the slot on the left side of the
camera (1F) with the contacts facing to the front and upwards until it engages.
Do not use force, otherwise the camera or the memory card could be damaged.
Only standard micro-SD memory cards can be used, HC cards are not supported.
8B Remove the memory card: To remove the micro-SD memory from the camera,
press on the memory card. There is an audible, quiet click and the card is pushed
out half way. It can then be pulled out completely using fingers.
8C Read the memory card: Then insert the micro SC memory card in a USB card
reader and connect it to a USB port of a computer. After a short installation routine,
the computer is ready to download the data from the model. Please follow the
appropriate procedure for your computer system.
8 MEMORY CARD
19
Publicité
