Important Information; The Installation - Plugwise Anna Mode D'emploi

The existing boiler wires that connect

the boiler to the thermostat have to be
connected to the on/ off connection
(0-230V, max. 5A) of the boiler. You can
find this information in the manual of
your boiler
The boiler wires that connect the boiler

to the thermostat, must at least be
cable type H05VVH2-F 2x1.0 mm²,
cannot be longer than 50 metres and
must not have a greater resistance
than 5 Ohm per wire. If this is the case
however, we advise you to have the
wires replaced.
Smartphone or tablet
2-pole switch contact -
on/off (0-230V, max 5A)
12 | English

Important information!

The installation.

Boiler
Additional power outlet
Check beforehand the availability and

quality of the network connection and
check also if a free power outlet is
available near the boiler.
Make sure you have the password

of the WiFi network to which you will
connect Anna.
Pull out the plug of the boiler before

you continue. Follow the safety
regulations.
Do not connect Anna directly to 230V

or directly to the boiler. This can cause
permanent damage to Anna.
Network router
Smile T230
near the boiler
Anna