EIBENSTOCK EBS 120 Notice Originale page 17

Application of Grinding Wheels
Type
Diamond Grinding Wheel
Concrete
Screed
Rapid K
Dust Extraction
Dust which occurs during your work is hazardous to health. That is why the
EBS 120 must be used with a vacuum cleaner, and a dust mask has to be
worn. The suitable Wet/Dry Vacuum Cleaner DSS 25 M / 50 M / 35 M iP is
available as accessory. It can directly be attached to the connection on the
dust hood.
Changing the brush rim
If the length of the brushes is – due to wear - smaller than 5 mm (extreme
formation of dust during grinding), the brush rim has to be replaced
completely. Pull out the worn brush rim and replace it by a new one.
Instruction for Use
Switch the machine on and put it carefully on the surface you want to work
on. Hold the tool with both hands and work with circular or linear
movements. For best working results: Don't put too much pressure on the
surface you want to work on.
Attention!
All other grinding works have to be done with the complete dust
guard.
Max.
Rated Speed
10,000 rpm
10,000 rpm
10,000 rpm
For grinding works right into edges of the wall one
segment of the dust guard can be opened by means of
the chucking device. This allows grinding on surfaces
which are usually hard to reach.
In this case, an increased amount of dust is possible.
Colour Application
gold, for finishing and facing
sand concrete, brick, lime sand-
stone, basalt, sandstone
yellow for finishing fresh and
green concrete, screed,
lime mortar plaster,
mortar, plaster, soft
limestone
blue for removing epoxy resin
and
two-component coatings
17