Helios CO2 AP-A Notice De Montage Et D'utilisation page 10

Installation and operating instructions
– Devices must only be connected to safety extra-low voltage and under dead-voltage condition.
– This device shall only be used for its intended purpose. Respective safety regulations issued by the VDE, the states, their control
authorities, the TÜV and the local energy supply company must be observed. The purchaser has to adhere to the building and safety
regulations and has to prevent perils of any kind.
– Please check delivery immediately on receipt for accuracy and damage. If damaged, please notify the carrier immediately. In case of
delayed notification, any possible claim may be void.
– No warranties or liabilities will be assumed for defects and damages arising from improper use of this device.
– Consequential damages caused by a fault in this device are excluded from warranty or liability.
– When storing for a prolonged time, the following steps are to be taken to avoid damaging influences: Protection by dry, air-dust-
proof packing (plastic bags with drying agent and moisture indicators). The storage place must be waterproof, vibration-free and
free of excessive temperature variations. Damages due to improper transportation, storage or commissioning must be verified and
are not liable for warranty.
– These devices must be installed and commissioned by authorised specialists.
– The technical data and connecting conditions of the mounting and operating instructions delivered together with the device are
exclusively valid. Deviations from the catalogue representation are not explicitly mentioned and are possible in terms of technical
progress and continuous improvement of our products.
– In case of any modifications made by the user, all warranty claims are forfeited.
– This device must not be installed close to heat sources (e.g. radiators) or be exposed to their heat flow. Direct sun irradiation or
heat irradiation by similar sources (powerful lamps, halogen spotlights) must absolutely be avoided.
– Operating this device close to other devices that do not comply with EMC directives may influence functionality.
– This device must not be used for monitoring applications, which serve the purpose of protecting persons against hazards or injury,
or as an EMERGENCY STOP switch for systems or machinery, or for any other similar safety-relevant purposes.
– Dimensions of housings or housing accessories may show slight tolerances on the specifications provided in these instructions.
– Modifications of these records are not permitted.
CO2 Monitor CO2 Monitor
10