Guided Tour - Ur1 Receiver - Samson AirLine AX1 Manuel D'utilisation

Samson AirLine
1 3
2 7
2: AF (Audio Frequency) Level control - This knob sets the level of the audio signal being output through both the balanced and
unbalanced output jacks on the rear panel (see #2 and #4 on page 8 in this manual). Reference level is obtained when the knob is
turned fully clockwise (to its "10" setting).
3: Peak LED - This LED lights yellow when output signal from the UR1 is at the onset of clipping (that is, when it is on the verge of
being distorted). If you see this light during operation, move the microphone further away or lower the output level of your
instrument or transmitter. For more information, see the section entitled "Setting Up and Using the AirLine System" on page 17 in
this manual.
Guided Tour - UR1 Receiver / Front Panel
4 5
4
1
6
SAMSON
UHF RECEIVER
8
6
1: Antennas (A and B) - The
antenna mountings allow full
rotation for optimum placement.
In normal operation, both Antenna
A (the antenna on the left) and
Antenna B (the antenna on the
right) should be placed in a vertical
position. Both antennas can be
folded inward for convenience
when transporting the UR1. See
the "Setting Up and Using the
AirLine System" section on page
17 in this manual for information
about antenna installation and
positioning.