Test Run - Mitsubishi Electric PAR-FL31MA Manuel D'utilisation

6. Test Run

B
7
1 Turn on the main power to the unit.
2 Set the Nrm/Set selector switch (on the back of the controller) to «Set».
A The
and
TEST RUN
CHECK
3 Press the
button.
MIN.
B
and current operation mode are displayed.
TEST RUN
4 Press the MODE (
from the unit.
5 Press the MODE (
blown out from the unit.
6 Press the FAN
7 Press the VANE
8 Press the
ON/OFF button to stop the test run.
9 After test run is complete, set the Nrm/Set selector switch to «Nrm».
Note:
Point the remote controller toward the receiver while following steps 3 though 8.
14
CHECK TEST RUN
˚C
AM
PM
AM
PM
NOT AVAILABLE
ON/OFF
MODE
CLOCK
FAN
VANE STOP START
HR. MIN.
begin to blink.
) button to activate FAN
) button to activate COOL
button and check whether strong air is blown out from the unit.
button and check whether the auto vane operates properly.
A
CHECK TEST RUN
AM
PM
AM
PM
NOT AVAILABLE
8
ON/OFF
45
6
After refiling batteries.
Press the reset button.
3
Nrm Set
2
9
mode, then check whether air is blown out
mode, then check whether cool air is
˚C
Reset