Operating Method; Starting Operation; Changing The Pre-Set Temperature - Mitsubishi Electric PAR-FL31MA Manuel D'utilisation

5. Operating Method

™ Each time signals are transmitted, the "
™ When the signals are received by the air-conditioner, a sound confirming reception will be heard.
Transmit again if no such sound is heard.

5-1. Starting Operation

™ Once the operation conditions are set, the same operations can be repeated just by pressing the
POWER ON/OFF.
ON/OFF
MODE
FAN
VANE STOP
HR.
Note:
There are some indoor unit models which do not support AUTO or HEAT mode. In these cases the
operation of the air-conditioner and the display of the remote control may differ.

5-2. Changing the Pre-set Temperature

ON/OFF
TEMP.
10
1. Press the POWER ON/OFF button.
Each time POWER ON/OFF is pressed, the operation will be
switched between ON and OFF.
∗ No LCD displays will light up while the controller is turned off.
CLOCK
2. Press the MODE button.
Each time the MODE button is pressed, the operation mode will
START
switch as shown below.
→ COOL → DRY → <AUTO> → FAN → <HEAT>
MIN.
If the LCD displays are not on, press the POWER ON/OFF
button.
1. To increase the pre-set temperature.
Press the
2. To reduce the pre-set temperature.
Press the
™ Each time the
perature changes in steps of 1 degrees Celsius.
Settable room temperature range
COOL, DRY
HEAT
AUTO
FAN
" mark will appear.
button.
button.
or button is pressed, the pre-set tem-
19 °C to 30 °C
17 °C to 28 °C
19 °C to 28 °C
No temperature setting can be made.