FF Europe EXBK04 Mode D'emploi page 26

Step 4: Install handrail components
- Fasten the handrails (6) into the mainframe (26)
with 2 pieces of M8*30 countersunk head screw.
Step 5: Install the seat post
- Pull out the round broaching from the mainframe (68), and
insert the seat tube (30) into the mainframe. Then tighten the
seat tube with the locknut, and fasten the seat post (24) to
the seat tube (30) with the wrench from the tool box.
Step 6: Install the computer
- Fasten the computer base (72) into the handrail tube and
main frame with the cross tapping screw (5), and adjust
the angle; insert the computer into the computer base
(72), connect the wires of the computer and handrail
tubes, as shown in the picture.
EN
ASSEMBLY INSTRUCTION
26