FF Europe EXBK04 Mode D'emploi page 24

EN
ASSEMBLY INSTRUCTION
Step1: Adjust bolt holes to make the product standing
- Take out the item from the box, then make it stand on the ground; push out the
positioning pun(34) as shown in Figure 1 to make the main frame stable;
- Rotate the main frame (68) in a clockwise direction as shown by the arrow No 2, then
insert the positioning pin (34) to another hole, as shown on Figure 2.
Step2: Install the front and rear stabilizers to the main frame.
- Attach the two stabilizers (16) to the main frame (26) and (68) respectively
using four pieces of M8*50 carriage screws (38), four pieces of M8 cap nuts
(36) and four pieces of camber washers (3).
- Then tighten the screws and nuts with the wrench from the tool box.
24