Philips SC1996 Mode D'emploi page 24

ENGLISH
24
Problem
The 'ready to flash'
light first blinks
orange and then
lights up orange
continuously
when I place
the appliance on
the skin and the
appliance does not
release a flash.
The 'ready to
flash' light does
not work when
I place the
attachment on
my skin, but the
cooling fan works.
The 'ready to
flash' light lights up
continuously, but
the appliance does
not produce a
flash when I press
the flash button.
Intensity light
1 continues to
blink and I cannot
change the setting.
All intensity lights
go on alternately.
All intensity
lights are blinking
simultaneously.
The appliance
produces a strange
smell.
Possible cause Solution
If this does not work, place the appliance on a part of
your body where it is easy to establish full skin contact, for
example on your lower arm. Then check if the 'ready to
flash' light works. If the 'ready to flash' light still does not start
blinking when you place the appliance on the skin, contact the
Consumer Care Centre in your country, your Philips dealer
or a Philips service centre.
The skin you are To prevent your skin from developing side effects, the
trying to treat is appliance does not work on skin that is too dark. You might
too dark. be able to use Philips Lumea Essential on lighter coloured
body parts. If this does not work either, contact the
Consumer Care Centre in your country, your Philips dealer
or a Philips service centre.
The overheat When the overheat protection has been activated, the fan
protection has still works. Do not switch off the appliance. Let it cool down
been activated. for approx. 15 minutes before you continue to use it. After
5 minutes the appliance switches off automatically. Then let
it cool down for 10 more minutes. If the 'ready to flash' light
still does not work when you place the appliance on the
skin, contact the Consumer Care Centre in your country,
your Philips dealer or a Philips service centre.
The appliance To reset the appliance, switch off the appliance and switch it
needs to be reset. on again. If the 'ready to flash' light lights up continuously, but
the appliance still does not produce a flash when you press
the flash button, contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service centre.
The attachment is Place the attachment on the appliance properly.
not placed on the
appliance properly.
The appliance To reset the appliance, switch off the appliance and switch it
needs to be reset. on again. If the intensity lights continue to go on alternately,
contact the Consumer Care Centre in your country, your
Philips dealer or a Philips service centre.
The appliance is Contact the Consumer Care Centre in your country, your
defective. Philips dealer or a Philips service centre.
The attachment Clean the attachment and the light exit window carefully. If
and/or the filter you are unable to clean the attachment properly, contact the
glass is dirty. Consumer Care Centre in your country, your Philips dealer
or a Philips service centre to replace the attachment.