Ways To Use The Panel Reader; Installing The Panel Reader And Antenna - Tru-Test XRP2i Guide Rapide

Ways to use the panel reader

4
The panel reader can be used in two ways:
1. Standalone - the panel reader saves each scanned tag in its internal memory. These records can be transferred afterwards, as
Section 8 – Getting information off.
described in
2. Connected – the panel reader immediately transmits every scanned tag to a connected device, such as an indicator.

Installing the panel reader and antenna

5
Example installation
In this example, a single panel reader is being used as part of a weighing system. The panel reader and antenna are mounted to a
cattle crush and the panel reader is connected to an indicator and load bars. When the animal enters the cattle crush, its EID tag
number is scanned by the panel reader and sent to the indicator.
Tru-Test indicator
Installation information
The panel reader and antenna can be mounted onto a flat surface (timber rails, concrete), or onto metal pipe-work, using the
hardware supplied. If you have a large antenna, the panel reader can also be mounted directly on the back of the antenna.
When mounting the antenna, do not damage it by drilling through it or piercing the surface with a screw. Use the
mounting holes provided.
Factors to consider:
The panel reader and antenna should be installed on the outside of a crush/chute, weigh crate or drafter so that it is not
•
damaged by animal movement.
Animal flow must be restricted to ensure that only one animal is within the antenna's read range.
•
• The location of the antenna in relation to metal bars or pipes needs to be considered. See the diagram in
Troubleshooting
.
• The positioning of the antenna is important to obtain an effective read of the EID tag:
XRP2i Panel Reader
Tru-Test antenna
EID tag
Section -
3