Tru-Test XRP2i Guide Rapide page 8

Menu name Options
3. DUPLICATES
4. READ MODE
5. TX POWER
4. DIAGNOSTICS
Supply voltage
Antenna voltage
and tuning value
Noise level
Read rate
Default settings marked **
8
Description
Complies with ISO 24631-6 e.g. 1000000964000000123456.
A 23 digit representation of the ISO format that uses a leading
A for animal tags and an R for non animal tags. e.g.
A0000000964000000123456 for an animal tag
R0000000964000000123456 for a non animal tag
Select to ensure the panel reader
twice in the same session.
Select to ensure the panel reader
in the same session.
Select to allow scanning of FDX and HDX tag types.
Select to allow scanning only of FDX tag types.
Select to allow scanning only of HDX tag types.
Select to maximise the read range of the panel reader to animal
tags.
Select to reduce the read range of the panel reader to animal
tags.
There are four diagnostics screens which provide troubleshooting information.
Select NEXT to scroll through the screens. If the values fall outside the normal
Section - Troubleshooting.
range, see
The power supply voltage is displayed and should be followed by (OK).
The antenna voltage is displayed and should be followed by (OK). The tuning
value is displayed. The graph should show a dot in the middle band and be
followed by (OK).
Displays the levels of interference being detected. The noise level should be in the
lower part of the graph.
Displays the reads per minute for the current location of the tag.
will not
record the same EID
will record the same EID twice
ISO
ISO23
ON**
OFF
DUAL**
FDX
HDX
HIGH**
LOW