Klarfit Rocketkid Mode D'emploi page 21

• Now connect a lower connecting rod with an upper connecting rod by
pushing the thinner side of the upper rod into the wider opening of the
lower rod and turn the rods into each other until the holes for the screw
connection are on top of each other. To do this, move the foam sheathing
to gain access to the respective ends.
• Insert a screw into the drill hole and tighten it. Be careful not to
overtighten the thread of the hole. Repeat steps 18+19 to join the
remaining poles together.
• Insert the lower end of the poles you have just connected into the holes on
the frame of the trampoline and align the poles so that the holes are on top
of each other.
• Insert a screw into the hole and tighten it. Repeat the process for the
remaining five poles. •
six eyelets with a metal ring at the top. Pull one of the eyelets over the top
of a pole and turn the eyelet until the metal ring is over the hole on the
pole. Be careful not to damage the net.
• Put a screw through the metal ring and tighten it. The safety net is now
firmly attached to the top of the pole. Repeat this step until all six eyelets
of the safety net are connected to the poles on the trampoline. Be sure to
attach the net correctly. The net should hang on the inside of the poles at
the end and not be twisted.
Now attach the safety net. The safety net has
EN
21