After Treating With Silk'n Facefx - Home Skinovations Silk'n FaceFX Mode D'emploi

Treating with Silk'n FaceFX for the First Time
The skin should be, clean, dry and free of any powder, gel or cream.
If necessary a light oil based serum may be applied thinly to the skin to help glide the device.
Allow serum to absorb into the skin before treating. See "cleaning the Silk'n FaceFX" section.
Remove Silk'n FaceFX APPLICATOR, ADAPTOR and other components from box.
Connect the ADAPTOR PLUG to the FaceFX
Connect the FaceFX to an electrical outlet
Press the POWER ON/OFF SWITCH. The green READY/TREATMENT INDICATOR
LIGHT (K) will start blinking, and shortly afterwards will be lit steadily.
Your FaceFX is ready for treatment.
Place the TREATMENT SURFACE on your skin. The LED light will automatically activate.
Apply light pressure while slowly moving the FaceFX APPLICATOR
in small circular motions. The TREATMENT SURFACE temperature
will slowly increase.
Perform the treatment for 5-7 minutes on each area.
It is recommended to apply a small amount of a moisturizing cream
on the treated skin areas after each session and to massage it gently
in circular motions.
What to expect when treating with Silk'n FaceFX?
During a Silk'n FaceFX session it is normal to experience and feel:
A Sensation of Warmth – During the Silk'n FaceFX session you may feel slight warmth.
This is normal and should disappear up to an hour after the session.
Some Mild Red Color – After each Silk'n FaceFX session you may notice a slight reddening
of the skin (mild erythema) over the treated area. This is normal and should fade within an
hour or two.
A Fan Noise - It is normal to hear a fan noise turning on and off during FaceFX treatments.
This is a safety feature that helps regulate the skin temperature during use.
Best results can be expected 3-7 weeks after completing the recommended course of treatment.

After treating with Silk'n FaceFX

When FaceFX session has been completed turn FaceFX off by pressing the POWER ON/OFF
SWITCH.
8