Worx WG191 Manuel D'utilisation page 12

ASSEMBLY & OPERATION
Action
Assembly
Assembling the Main Handle
Assembling the Safety Guard See Fig. B
Installing and Removing the
Battery Park
Checking the Battery Charge
Condition
Charging the battery pack
• More details can be found
in WA3859's manual
Operation
Trimming
Adjusting the Trimmer Head
Adjusting the Auxiliary Handle See Fig. F
12 Edging
Edger wheel storage
Command feeding the line
Manually feeding the line
Replacing the trimmer Spool
Manually winding the line
OPERATION INSTRUCTIONS
WARNING! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
13" Grass Trimmer/Edger
1. COMMAND FEEDING THE LINE
(See Fig. I)
Your trimmer is equipped with a Command
Figure
Feed System. For efficiently feeding the line,
just press the command feed button until you
hear the 'clattering' noise of the line cutting.
See Fig. A
The motor will shut off when pressing the
Command Feed button and will restart when
releasing the button. During that process the
See Fig. C1,&
line will automatically feed additional line for
C2
cutting.
See Fig. C3
2. MANUALLY FEEDING THE LINE
(See Fig. J)
Turn off the trimmer and remove the battery.
See Fig. C4
If required, line can be fed out manually. To
operate, press and release manual Line Feed
Button, while gently pulling out the line until
See Fig. D
it is long enough to reach the Line Cutter.
If the line extends past the Line Cutter, too
See Fig. E1
much line has been fed out. If too much line
& E2
is fed out, remove the Spool Cap and turn
Spool counter-clockwise until the line is at the
desired length.
See Fig.
3. MANUALLY WINDING THE LINE
G1~G4
(See Fig. N,O,P,Q)
Take approximately 20ft (6m) of line. Insert
See Fig H
.080"(2mm )of line into the Spool holes and
wind line in the direction of the arrows on
See Fig.I the top of the Spool. Leave approximately
4" (100mm) of line unwound and place into
the cleat. Ensure that the line is neatly coiled
See Fig. J
on the Spool. Failure to do so will impair the
efficiency of the automatic line feed. Then fit
the Spool as described above in "Replacing
See Fig.,K L M
the trimmer line and Spool"
See Fig. N ,O,
P , Q
STORING YOUR GRASS
TRIMMER
TO STORE YOUR GRASS TRIMMER
The trimmer is provided with a hanging slot
for storing the trimmer on the wall.(See Fig.R)
Store in a dry place where the trimmer and
battery can be protected from damage.
Always remove the battery pack
from your trimmer after use.
EN