General International BT8010 Manuel D'instructions Et D'assemblage page 7

FUNCTIONAL
DESCRIPTION
ASSEMBLY PROCEDURE
WARNING! Serious personal injury could occur if you connect the
machine to the power source before you have completed the setup
process. Do not hook up the machine to a power source until instructed
to do so.
1. TAKE THE IMPELLER / SEPARATOR assembly (D).
2. REMOVE THE TWO NUTS where shown (fig 3) on each side.
A Filter bag support
B Filter bag
C Belt clamp (1 of 2)
D Impeller / separator assembly
E Belt clamp (1 of 2)
F Dust collection bag
G Base
H Cross brace
I Hose fitting
J Hose clamp (2)
K Hose
L Vertical support (2)
M Short carriage bolts (4)
N Nuts (8)
O Long carriage bolts (4)
P Y splitter / reducer with cap
170227
7