Publicité
Les langues disponibles
Les langues disponibles
OPERATING
INSTRUCTIONS
CAUTION: Always turn on the dust collector before starting your
dust-producing machinery and always stop the dust-producing
machinery before turning off the dust collector.
BEFORE STARTING
1. To minimize airborne dust, make sure that all hoses, fittings and clamps
are secure and airtight.
2. For maximum system efficiency,make sure a cover is installed on any
unused hose inlet openings.
3. Never operate the machine without the filter bag and the collection bag
properly installed.
4. The sound level of this machine is rated at approximately 80-85 dB
during operation. Make sure that adequate hearing protection is used
and that the overall sound level within the working environment is taken
into consideration.
CAUTION: Make sure the switch is in the "OFF" (
plugging in the power cord.
MAINTENANCE &
SERVICING
WARNING! Make sure the switch is in the "OFF" (
unplug the unit from the power source before performing any
maintenance.
This machine operates on 120 V; if you suspect any electrical problems
call a qualified electrician to do the verification of the electrical circuit or
the machine. If you need further help with your dust collector contact your
General
International distributor or our Technical Service Department at
®
1-888-949-1161.
● All bearings are sealed and permanently lubricated. No further
lubrication is needed.
● Periodically inspect all hardware, fittings and fasteners that may have
loosened due to vibration - retighten as needed.
● Keep the outside of the unit clean and wipe off excessive dust or dirt
with a dry rag.
● Clean the filter bag on a regular basis and replace as needed.
● Periodically inspect inside all pipes, fittings, hoses, blast gates, and
connectors for accumulated dust build-up or other obstructions, and
clean as needed. Remove sections and vacuum or manually remove
debris as needed.
● Check and if necessary replace all damaged parts or components.
● Do not operate with a damaged canister filter - replace damaged filter
immediately.
● Periodically inspect the power cord and plug for damage. If necessary,
replace the power cord and plug at the first signs of visible damage.
● Use only recommended parts and accessories. The use of parts or
accessories NOT recommended by GENERAL
result in a risk of injury or damage to the machine.
10
) position before
) position and
INTERNATIONAL may
®
Publicité
