Safety Instructions - SilverCrest SKME 150 A1 Mode D'emploi

Safety instructions

RISK OF ELECTRIC SHOCK
Connect this appliance only to correctly installed mains power sockets sup-
►
plying a mains voltage of 220 - 240 V ~ /50 Hz.
If the supply cord is damaged, it must be replaced by the manufacturer, its
►
service agent or similarly qualifi ed persons in order to avoid a hazard.
In event of operating malfunctions and before cleaning the appliance,
►
remove the plug from the mains power socket.
Always remove the power cable from the socket by pulling on the plug, not
►
on the power cable itself.
Do not crimp or crush the power cable, and route the cable so that it can-
►
not be stepped on or tripped over.
The appliance must not be exposed to moisture or used outdoors. If the hous-
►
ing is penetrated by liquid, disconnect the appliance from the mains power
socket immediately and have it repaired by a qualifi ed technician.
NEVER take hold the motor unit, the power cable or the plug with wet hands.
►
If the power cable or the motor unit are damaged, you must have the
►
appliance repaired by qualifi ed technicians before using it again.
RISK OF ELECTRIC SHOCK
Do not open the housing of the appliance motor unit. Should you do so,
►
the safety of the appliance is no longer assured and the warranty will
become void.
Disconnect the appliance from the mains power source immediately after
►
use. The appliance is completely free of electrical power ONLY when
unplugged.
Never immerse the motor unit of the appliance in liquid and do not al-
low any liquids to enter the casing of the motor unit.
SKME 150 A1
GB
IE
3