Delta JT360 Manuel D'utilisation page 17

4. CAREFULLY rotate the cutterhead by turning the belt
by hand. The knives should just touch the straight
edge.
5. If the knife is high or low at either end, slightly
turn the four screws (D) Fig. 41, in the knife
locking bar clockwise to loosen using the
wrench (E) supplied. Then adjust the height of
the knife by turning the knife raising screws (F)
Fig. 42, counterclockwise to lower and clockwise to
raise the knife.
NOTE: If the knife is to be lowered it will be necessary to
wear protective gloves and carefully push down on the
knife with a piece of scrap wood after screws (F) have
been turned.
6. Repeat these procedures for adjusting the remaining
two knives.
7. If the knives are set too low, the result will be as
shown in Fig. 43, and the finished surface will be
curved.
8. If the knives are set too high, the work will be gouged
at the end of the cut, as shown in Fig. 44.
9. As a final check, run a piece of work slowly over the
knives for 6 to 8 inches. The wood should rest firmly
on both tables as shown in Fig. 45, with no open
spaces under the finished cut.
Fig. 44
WORK
OUT-FEED
TABLE
KNIVES
SET TOO HIGH
IN-FEED TABLE
CUTTER
Fig. 40
Fig. 41
D
F
Fig. 43
OUT-FEED
TABLE
KNIVES
SET TOO LOW
Fig. 45
OUT-FEED
TABLE
KNIVES AT
CORRECT HEIGHT
17 - English
C
A
B
D
E
F
Fig. 42
WORK
IN-FEED TABLE
CUTTER
WORK
IN-FEED TABLE
CUTTER