Kapro Prolaser Plus 872 GREEN Manuel D'utilisation page 11

Working in Manual mode:
In Manual mode the 872's self-leveling mechanism is disabled and
the laser lines can be set at any slope required.
1. Press the Manual push button mode
project the cross lines and the red LED near the push
will light up. The green LED of the laser beams near
button
V/H push button will light up.
2. Choose the beams that you want to work with by pushing
the Beam Selector push button V/H
3. To mark a slope, tilt the laser using the adjustable folding
legs to adjust the right angle and the height.
4. To turn the manual mode off, press again the Manual
push button
5. While in Manual mode turning the locking switch #1 from
OFF to ON will turn off the Manual mode and the red LED
near the push button. The automatic self – leveling
will be activated if the laser level is within the self – leveling range.
.
. The laser will
11