Positioning The Movement Sensor Pad - Angelcare AC117 Manuel De L'utilisateur

STEP 2 - POSITIONING THE MOVEMENT SENSOR PAD
2.1 - POWERING THE MOVEMENT SENSOR PAD
When using the Sensor Pad for the first time, you will need to insert the provided
CR3032 battery.
2.2 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
IMPORTANT
If your cot does not have a solid, stationary, completely flat, firm surface including a spring
or slat base, place a hard board between the crib base and the Sensor Pad, to ensure correct
operation.
The hardboard support must measure at least 33 x 33 cm (13" x 13") and 6 mm (1/4") thick. This
hardboard support must be larger than the Sensor Pad surface area.
The Sensor Pad functions with any size and type of mattress except memory‑foam mattresses,
hollow frame mattresses and water beds. The hardboard maintains a constant pressure on the
Sensor Pad, enabling it to detect the baby's movements even when the baby is at the edges of
the cot.
IMPORTANT
• Ensure the Sensor Pad is in the center of the cot – printed or Logo side up – on top of the hardboard. Check
the position is central before each use.
• BEFORE FIRST TIME USE: Test that the unit is ready for use – refer to the Full User Manual to check if
installation is correct.
Sensor Pad
1) Remove the battery cover using a coin.
Turn in the direction of the arrow.
2) Place the included battery (CR3032) in
the compartment.
Note: The + symbol should be facing
up.
3) Replace the battery cover (the two dots
will line up). The Sensor Pad is now ON.
1) Remove the mattress from
the cot.
2) Place the Sensor Pad ‑ Angelcare
side up ‑ in the center of the mattress.
It should be centered on the hardboard
if your cot requires a hardboard
support.
3) Replace the mattress.
E
N
Hardboard
logo
®
65