Setup Requirements - Angelcare AC117 Manuel De L'utilisateur

the alarm will not sound if it continues to detect any movement other than your
baby's. Be sure all vibration sources are eliminated before using the monitor.
12.19 You may experience false alarms for several reasons. The most common reason
is the Nursery Unit has not been turned OFF after you have removed your baby from the
cot. Another reason is the Sensor Pad has not been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm surface with the Angelcare
side facing up. The sensitivity level may also need to be adjusted. Refer to
Step 5.4. Always be sure to immediately check on baby whenever an alarm sounds.
12.20 Sensor Pad ‑ Your Sensor Pad can be used in any cot that is stationary.
If the cot has a spring or slat base, place a hard board between the cot base
and the Sensor Pad measuring at least 33 x 33 cm and 6 mm thick. Only
use your Angelcare monitor in a stationary sleeping environment such
®
as a cot where the Sensor Pad can rest on a completely flat, firm surface.
The Sensor Pad is made of plastic and does not permit the air to circulate.
Therefore, mildew build up could develop underneath the mattress in the Sensor
Pad area. We suggest rotating the mattress regularly to prevent any mildew.
13. IMPORTANT SAFETY INSTRUCTIONS RELATED TO USE OF BATTERIES
13.1 Use ONLY the type and size of battery specified in the owner's manual. There
is a risk of explosion if battery is replaced with an incorrect type.
13.2 Charge the battery for 10 hours prior to first use. Be sure to have the monitor
in the OFF position during this period. ONLY use the adapters included with your
monitor.
13.3 DO NOT use these adapters with any other equipments.
13.4 When unplugging the adapter from the Nursery Unit, be sure it is switched
to the OFF position.

SETUP REQUIREMENTS

INCLUDED:
Parent Unit
2X
2 Rechargeable AAA Batteries
(for Parent Unit)
logo
®
Nursery Unit
Wireless movement Sensor Pad
* Always place Angelcare
13.5 DO NOT dispose batteries in fire. They may explode. Check with local
regulations for possible special disposal instructions.
13.6 Exercise care in handling batteries in order not to short out the batteries
with conducting materials such as rings, bracelets and keys. Overcharging, short
circuiting, reverse charging, mutilation, or incineration of batteries must be avoided
to prevent one or more of the following occurrences: release of toxic materials,
release of hydrogen and/or oxygen, gas and rise in surface temperature.
13.7 DO NOT attempt to rejuvenate the battery provided with or identified for use
with this product by heating them. Sudden release of battery electrolyte may
occur, causing burns or irritation to eyes or skin.
13.8 If and when necessary, the battery must be replaced with identical new ones
or equivalent (volts and size).
13.9 Reverse polarity installation of the batteries in the end product must be
avoided. Reverse insertion of batteries can cause charging, and that may result
in leakage or explosion.
13.10 Remove the battery from the Parent Unit if you store the product over 30
days because the battery could leak and damage the product.
13.11 Discard 'dead' batteries as soon as possible since 'dead' batteries are more
likely to leak in a product. If a battery has leaked or vented, it should be replaced
immediately using protective gloves.
13.12 DO NOT store this product, or the battery provided with or identified for use
with this product, in high‑temperature areas.
Model AC117
Sound and Movement Monitor
Tabletop stand
(for Nursery Unit)
logo side up *
®
2X
2 AC adapter
(for Parent Unit and
Nursery Unit)
CR3032 battery
(for Sensor Pad)
E
N
63