exodraft RS Serie Mode D'emploi page 30

30 • UK
Before itting onto a steel chimney:
Step Action
1 A lange (C) is used, itted so that the spigot end sits
inside the chimney (D).
2 Place the mineral wool mat (A) on the lange (C) with
aluminium foil facing upwards and cut a hole in the
mineral wool mat, the hole being the same diameter as
the lange hole.
3 Cut the corners of the mineral wool mat, so there is
room to it the vibration dampers (B).
If a temperature sensor is to be installed with the
chimney fan, cut the aluminium foil on the mineral
wool mat to make room for the sensor; this also ensures
that the mat sits level on the chimney.
4 Fit the lange to the chimney fan, with the use of
vibration dampers supplied with the lange.
5 The fan can now be itted onto the chimney.
3000112 RS DK DE NO SE UK NL FR 211014
B
C
D
E