Omega BL600 Serie Mode D'emploi page 13

EASY CLEANING & CARING TIPS
CLEANING
Do not put the container assembly & blender base assembly in the dishwasher.
1. Before first use and after every use, separate container parts from the base.
2. Add cleaning solution to the container. Use water (less than 115°F/46°C) and a
non-sudsing detergent.
3. Scrub and flush out the container interior lid and feeder cap to remove food residue.
4. Empty container.
5. Fill container 1/4 full with fresh washing solution and place it on the base.
6. Replace the lid on the container and run the blender on high speed for 2 minutes.
7. Repeat step 5 using clean rinse water.
8. Wipe down the container, feeder cap, and lid with a soft cloth or sponge.
9. Wipe the exterior of the base with a damp cloth or sponge then dry thoroughly.
The base contains electrical components: do not immerse, use a high-pressure
washer, or use a dishwasher to clean the base.
10. Wipe any excess food particles from the power cord.
CARING TIPS
To care for your blender, please read the tips as follows:
1. Periodically check all parts before reassembly, as use of damaged or
non-recommended parts could result in a severe personal injury and/or damage to
the blender.
2. Blades: If the processing blades are stuck or difficult to turn, DO NOT USE BLENDER.
Unplug the blender. Check the blades by carefully turning in a counterclockwise
direction, where the opposite edges are sharp. Blades should turn freely.
3. Container: If the Eastman Tritan™ Container is cracked, DO NOT USE BLENDER, further
use could result in the container breakage during use.
4. Blender Base: Never immerse the blender base in water. Unplug unit. The housing
can be cleaned with a damp cloth.
5. Motor: The motor is permanently lubricated and does not require any additional
lubrication.
All manuals and user guides at all-guides.com
11