Homelite UT80522G Manuel D'utilisation page 12

WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
TOOLS NEEDED
See Figure 1a.
 10 mm Wrench (7/16 in.)
ATTACHING THE WHEEL ASSEMBLY
See Figure 2.
 Locate the axle, hitch pins, washers, and wheels.
 Slide the axle through the hole in the center of the wheel.
 Slide the washer onto the axle.
 Lift the machine and slide the axle into the wheel mounting
hole in the machine base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
INSTALLING THE HANDLE
See Figure 3.
Push and hold the push-pin button on the side of the handle
as you slide the handle onto the frame.
NOTE: Before use, pull the handle up until the push-pin button
snaps through the locking slots to secure the handle in place.
ASSEMBLY
INSTALLING THE UPPER AND LOWER
SPRAY WAND HOLDER
See Figure 4.
 Align upper spray wand holder with holes in handle, as
shown.
 Slide long side of spray wand holder through handle and
tighten securely with lock nut.
 Place lower spray wand holder over the holes in the frame
as shown. The loop should be at the top and the long end
should extend through the frame.
 Install 1/4-20 (7/16 in.) hex nut and tighten securely.
ASSEMBLING THE TRIGGER HANDLE
See Figure 5.
 Place the threaded end of the spray wand in the connector
on the end of the trigger handle.
 Turn the connector clockwise until it stops. This secures
the spray wand in place.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 6.
 Screw the collar on the high pressure hose into the trigger
handle inlet coupler by turning the hose collar clockwise.
Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.
 Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE
TO THE PUMP
See Figure 7.
 Completely uncoil and straighten the high pressure hose
to prevent kinks.
NOTE: See Using The High Pressure Hose in Operation
for more information about using the high pressure hose.
 Align the collar on the threaded outlet on the pump.
 Insert the hose on the end of the high pressure hose collar
into the threaded outlet.
 Turn the collar clockwise to tighten the hose securely to
the pump.
NOTE: Be careful to avoid cross-threading, which can
cause the hose to leak during use.
 Pull on the hose to be certain it is properly secured.
Page 8 — English