GE GLD6900 Serie Instructions D'installation page 12

Installation Instructions
STEP 20–DISHWASHER WET TEST
Turn on power supply or plug power cord into outlet, Turn on power supply or plug power cord into outlet,
■
if equipped.
Latch door. Latch door.
■
Push "Rinse Only" button. Push "Rinse Only" button.
■
Push Start/Reset pad one time. Dishwasher should start. Push Start/Reset pad one time. Dishwasher should start.
■
Check to be sure that water enters the dishwasher. If water Check to be sure that water enters the dishwasher. If water
■
does not enter the dishwasher, check to be sure that water
and power are turned on.
Check for leaks under the dishwasher. If a leak is found, turn Check for leaks under the dishwasher. If a leak is found, turn
■
off power at the breaker, then tighten connections. Restore
power after leak is corrected.
Check for leaks around the door. A leak around the door could Check for leaks around the door. A leak around the door could
■
be caused by door rubbing or hitting against
adjacent cabinets. Reposition the dishwasher if necessary.
See Step 15.
The dishwasher will drain and turn off about 5 minutes after The dishwasher will drain and turn off about 5 minutes after
■
it was started. Check drain lines. If leaks are found, turn off
power at the breaker and correct plumbing as necessary.
Restore power after corrections are made. See Steps 7
and 17.
Open dishwasher door and make sure most of the water has Open dishwasher door and make sure most of the water has
■
drained. If not, check that disposer plug has been removed
and/or air gap is not plugged. Also check drain hose to be
sure it is not kinked underneath or behind dishwasher. See
Step 17.
Press Start/Reset pad once again and run dishwasher Press Start/Reset pad once again and run dishwasher
■
through another "Rinse Only" cycle. Check for leaks and
correct if required.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
GE Consumer & Industrial
General Electric Company
Louisville, Kentucky 40225
ge.com
STEP 21–REPLACE TOEKICK
• Place toekick against the legs of the dishwasher.
� � � � � � �
����������
������
Figure CC
• Align the toekick with the bottom edge and make sure it is
against the fl oor.
���������
• Insert and tighten the two toekick attachment screws. The
toekick should stay in contact with the fl oor.
Tip: Make sure toekick is against floor to minimize noise.
STEP 22–LITERATURE
• Be sure to leave complete literature package, these
Installation Instructions and product samples and/or coupons
with the consumer.
© 2006 General Electric Company
Pub. No. 31-30231
Dwg. No. 206C1559P170
ND 07C-2173 (3/07)