Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
BEAR VIDEO CAM
1. Power by either the Battery or DC power of the Bear video camera.
2. Position the video camera in the desired location.
NOTE: The transmission range of the Bear video camera at open
side up to 150ft. Real distance is depends on its operating
environment. If you are receiving poor video images from the
camera, try shortening the transmission range. Reposition and/or
adjust the Bear video camera if video transmission is being
degraded by obstructions in its operating environment.
3. Select the desired transmission channel for the Bear video camera.
NOTE: The Bear video camera has four different transmission chan
nels. The Bear video camera has been set to transmit on C at the fact
ory. Do not set and/or use more than one video camera on the same
transmission channel in order to prevents signal interference and
unclear picture reception.
•Remove the Channel Switch rubber grommet from the Bear
Use a small, blunted, pointed object to slide Channel Switch
inside of the base opening, video camera front base,as desired
(Channel 1-4)
•Securely reattach the Channel Switch rubber grommet onto the
video camera base.
NOTE: Reference the "Receiver" section to update the receiver
channel selection.
4. Zip back of the Bear Camera and pull out of the battery zoom.
5. Put a 9V battery into battery compartment.Please use 9V ALKALINE
Battery for battery source.
6. OR connect the AC Power Adaptor into adaptor jack.Then, plug the
AC Power Adaptor into a standard 120V /230VAC electrical outlet.
NOTE: Make sure to move the batteries out of battery compartment
before plugging AC Power Adaptor.
7. Slide the ON/OFF Switch to the ON position.
8. When DV 9V Plug in Jack, the Battery power will Auto switch off.
Publicité
