Publicité
Les langues disponibles
Les langues disponibles
V4.0
5.
Loosen the set screw and insert the handle into the handle socket (#21).
Make sure the handle opening fits over the square bolt. Tighten the set screw.
6.
Twist the handle to the right to close the release valve.
7.
Pump to raise the saddle. Stop just before the saddle contacts the load's
lift point. Inspect the saddle's position and adjust if necessary.
8.
Pump slowly until the ram is supporting the load. Continue to pump as
normal to lift the load to the desired height.
9.
Lift the vehicle to a height that leaves enough room to place the jack stands.
10. Position jack stands underneath the load. Consult the vehicle owner's
manual for proper placement.
LOWERING A LOAD
WARNING! Dynamic shock loads are created by quick opening and closing of
the release valve when lowering the load. The resulting overload may cause
the hydraulic system to failure, which could result in severe personal injury
and/or property damage.
WARNING! Before lowering the load or vehicle, ensure that there are no
obstructions underneath and that all people are standing clear.
1.
Open the valve by gradually twisting to the left.
2.
The load will begin to lower.
3.
Twist right to slow and left to increase the rate of descent.
4.
Remove the jack once the load is on the ground or a support mechanism
like jack stands.
5.
The ram should fully retract. If it does not, push down on it until it
is seated.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Keep the tool handles clean, dry and free from oil/grease at all times.
Visit www.princessauto.com for more information
3 Ton Speed-Lift Floor Jack Floor Jack
8760928
9
Publicité
