Publicité
Les langues disponibles
Les langues disponibles
ROUGH-IN ELECTRICAL
This hood is corded. A receptacle in the ceiling or wall is required. Incoming power
should be located as shown in Fig. 10 (top view) or Fig. 11 (front view).
WARNING: Electrical wiring must be done by a qualified person in accor-
dance with all applicable codes and standards.
Wall
6" Duct
Ducted either Vertical or Horizontal.
Fig. 10.
INSTALL THE DUCTWORK
DUCTED HOODS ONLY
CAUTION: To reduce the risk of fire,
use only metal ductwork.
1. This hood is configured for 6" duct.
2. Decide where the ductwork will run
between the hood and the outside.
Fig. 12.
3. A straight, short duct run will allow
the hood to perform most efficiently.
4. Long duct runs, elbows, and transi-
tions will reduce the performance of
the hood. Use as few of them as pos-
sible. Larger ducting may be required
for best performance with longer duct
runs.
5. Install a roof or wall cap. Connect
round metal ductwork to cap and
work back towards the hood loca-
tion. Use duct tape to seal the joints
between the ductwork sections.
Center Line
of Hood
4"
8"
Electrical
Box Location
FIG. 10
- 9 -
Electrical
Box Location
Top of Hood
6" Duct
Electrical box location is not mounted
against ceiling. Fig. 11.
ROOF CAP
ROUND
ELBOW
6"
DAMPER
HOOD
18-1/2" TO 30-1/2" ABOVE
COOKING SURFACE
(see "INSTALL MOUNTING
BRACKETS" section for
mounting restrictions)
1/2"
4"
Center Line
of Hood
FIG. 11
6-INCH
ROUND DUCT
WALL
CAP
FIG. 12
Publicité
