AquaScape Pompe avec deux sorties Instructions Et Entretien page 5

SUGGESTED POND INSTALLATION
2. Lay out the aeration tubing with pre-installed check valves.
3. Attach the end of aeration tubing with the pre-
installed check valve to the front nozzle on the air
pump. The check valve is designed to prevent
water from siphoning back through the tubing and
entering into the compressor. Failure to install the
check valve may result in the compressor being
permanently damaged, voiding the warranty.
4. Attach the Aeration Discs
to the opposite end of
the aeration tubing.
www.aquascapeinc.com | ☎
5. Position the Aeration
Discs in the bottom of the
pond. We recommend
separating the Aeration
Discs apart from each
other to maximize the
circulation throughout
the entire pond.
CAN 1-866-766-3426 | ☎
6. Connect the pump to an
outlet that is protected
by a ground fault circuit
interrupter (GFCI).
US 1-866-877-6637
Check valve
OR
Tip – Small rocks or gravel
can be used to hide the
aeration tubing and prevent
it from fl oating, or to
secure the Aeration Disc
in the proper position.
5