Installation - Permobil "B" Mounting Block - Permobil BodiLink Corpus Manuel D'utilisation

INSTALLATION - PERMOBIL "B" MOUNTING BLOCK

Corpus (20" height) and Corpus HD (21" height)
1
If the head support hardware stem is inserted in the mounting block (B), turn the knob (A) counterclockwise to release it. Remove
the hardware stem; set aside.
2
Using the 5mm hex key, loosen the screws (C) to release the washers (D), and the double nuts (F) from the mounting bracket (E).
3
Move the back support cover (not shown) allowing access from both sides to the head support holes on the back support shell (G).
4
Align the mounting bracket (E) with the head support holes on the back support shell (G) and the double nuts (F).
5 Replace the screws (C) and the washers (D) and tighten.
6 Replace and secure the back support cover.
7
Insert the hardware stem into the mounting block (B) and turn the knob (A) clockwise to secure.
IMPORTANT! Make sure that at least ½" of the hardware stem is completely through the bottom of mounting block (B) at all times.
See the warning in the "Important Safety Information" section in this manual.
Note: See SUPPORT PAD installation, positioning and adjustment instructions in this manual to make final adjustments.
E
F
D
Alternate options when using the Permobil "B" Mounting Block.
1
Remove the screws (G) and the washers (H) on the mounting block (B).
2
Align the mounting block (B) with the alternate holes on the mounting bracket (E).
3 Replace the screws (G) and the washers (H) and tighten.
E
B
BodiLink on Permobil Corpus Operation Manual
A
B
C
G
H
E
F
G
D
Standard and Alternate Mounting Block Placement on the Mounting Bracket
6
C
HS