TOOLWAY Tooltech 100084 Manuel De L'utilisateur page 4

OSCILLATION INSTRUCTIONS
5. Attach the rear guard to the screws found on the motor and
secure them together using four bowl washers, four spring
washers, and four nuts from step 4.
6. Attach the blade to the shaft on the motor and secure them
together using two screws.
7. Assemble Front Guard to Rear Guard by fixing both Guards
together with clips.
8. Secure the assembly on the front and rear guard by
tightening the screw and nut on the bottom of them.
Position A - To make the fan head oscillate
To make the fan head oscillate: loosen the screw and move the position
A. lighten it back. Note: the screw is preset at position A at the factory.
To stop the fan head oscillate: loosen the screw and move to position
B. lighten it back. Caution: Switch off the fan before adjusting fan head oscillation .
4
Position B - To stop the fan head oscillate