TOOLWAY Tooltech 100084 Manuel De L'utilisateur page 3

ASSEMBLY INSTRUCTION:
2. Loosen and remove the two screws (1) on the height adjusting base on the upper connecting pole (2). Place the spring
(4) into the standing pole (4). Insert the upper connecting pole (2) into the standing pole (4), making sure the holes
on the height adjusting base and the standing pole (4) are aligned. Insert the two screws (1) into the standing pole (4)
and tighten them. Adjust the height of the upper connecting pole (2) as desired and secure using the adjusting knob.
3. Assemble the motor.
1. Insert five screws (2) through the holes in the standing pole
(1) and then attach the standing pole to the base (3).
4. Remove four sets of hexagonal nuts,
spring washers, and big washers from the
motor. Save them for step 5.
3