Helo-Wt Technology In A Piccolo Pure Heater - Helo PICCOLO Pure Manuel D'installation Et D'utilisation

Chauffe-sauna électrique
Table des Matières

Publicité

Installation and User Manual Piccolo Pure

2.15. Helo-WT technology in a Piccolo Pure heater

Helo Water Tech (Helo-WT)
out a separate heat source. Moisturised air improves the sauna climate, and various fragrances and salts can be
evaporated to make the sauna experience more enjoyable.
A water tank with a lid is delivered with the heater; the tank can be installed in the wider gap between the heating
elements. The water tank can be installed when approximately 2/3 of the heater stones have been stacked.
The tank has a capacity of approximately 1,4 litres. Bringing water to the boil when the tank is full takes approximately
1-2 hours depending on the set temperature.
It is recommended to pour water into the tank when the heater is turned off. Water is poured through the grate on the lid.
You can pour less water into the tank if the bathing time is shorter.
The water tank must be removed and impurities, such as limescale etc. removed every so often. The stones surrounding
the tank must be removed during cleaning, so that the tank can be lifted more easily.
When the water is boiling, the moisture levels in the sauna remain high. This means that the temperature can be kept
lower while still experiencing pleasant heat. More heat and moisture can, if necessary, be created by throwing water on
the stones on top of the heater.
Mild fragrance essences, suitable for heater use, can be put in the water tank.
You can, for example, put mountain salt crystals on the lid of the water tank. They dissolve into the steam and evaporate
into the air. If mountain salt crystals are placed in the water tank, the salinity of the water will remain 26%.
Do not use the tank without water.
Remove the tank from the heater if the steam function is unpleasant. The tank will deform if it overheats.
If you remove the tank from the heater, replace it with sauna stones.
1
1
uses the heater's thermal energy to heat water and raise the moisture level with-
2
2
3
3
4
4
H O
2
max1,4 l
12

Publicité

Table des Matières
loading

Table des Matières