Edirol AUDIOCAPTURE UA-5 Démarrage page 50

UA-5 application guide
Using ASIO Direct Monitor
If you are using the UA-5 from an ASIO2.0-compatible application in Advanced
mode, the UA-5's Input monitor switch can be controlled automatically from the
application.
1
As described in "Opening the special driver settings dialog box (p.
51)", open the driver settings dialog box.
2
Make the following settings.
Check the "Use ASIO Direct Monitor" check box.
3
Click [OK] to close the driver settings dialog box.
* Depending on your application, there may also be an ASIO Direct Monitor setting
among the audio settings of your application. For details, refer to the operation manual
for your application.
* When using ASIO Direct Monitor, monitoring may switch on/off at unexpected times,
depending on the application settings and on the recording procedure. If this occurs,
uncheck the check box in step 2 to disable ASIO Direct Monitor.
50