Edirol AUDIOCAPTURE UA-5 Démarrage page 19

fig.05-6e_30
11
The SETUPINF dialog
box will appear.
You are now ready to install
the driver.
Drag the title bar to move the
SETUPINF dialog box into the
upper part of the screen.
* Do not click [OK] at this time.
12
With the power turned off, use a USB cable to
connect the UA-5 to your computer.
13
Set the UA-5's mode select switch to the ON
position.
14
Turn on the power of the UA-5.
Connect the AC adaptor to the UA-5's AC adaptor jack, and
insert the AC adaptor's plug into an AC power outlet. Then,
turn on the power of the UA-5.
If in step 5 the "File
signature verification"
setting was not set to
"Ignore", a "Digital
signature not found"
dialog box will appear.
If "File signature verification" is set to "Warn,"
1.
Click [Yes].
2.
Continue the installation.
If "File signature verification" is set to "Block"
1.
Click [OK].
2.
When the "New hardware detection wizard"
appears, click [Finish].
3.
Perform the installation as described in the
"Troubleshooting" section on Device Manager shows
Getting Connected and Installing Drivers (Windows)
If a message of "The driver is
already installed" appears,
you can connect the UA-5 to
your computer and use it.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
19