Troubleshooting - GreenWorks Pro GW80VSNW200 Guide D'utilisation

TROUBLESHOOTING

PROBLEM
The handle is not in
position.
The snow thrower
doesn't start.
The motor is on, but the
impeller does not turn.
The snow thrower
leaves a thin layer of
snow behind.
POSSIBLE CAUSE
The bolts are not properly
seated.
The battery is not
charged.
The switch is defective.
Battery is too cold.
The battery is not
attached to the motor.
Battery may require
service or replacement.
The belt is damaged.
The scraper is worn.
SOLUTION
Make sure the bolts are correctly installed
through the handle bars. Check to see if the
hand knobs are tight. Refer to Assembling
the Handle section in this manual.
Charge the battery by following the
procedures in the battery and charger
manual.
Have the switch replaced by an authorized
service center.
Remove battery from snow thrower. Place
battery on charger and allow to charge for
10 minutes. Remove from charger and
install in snow thrower for use.
Check the connection between the motor
connector and the battery.
Call toll free helpline, at 1-855-345-3934 or
replace battery.
Replace the belt (see the section entitled
Replacing the Drive Belt).
Inspect the scraper for wear or damage.
Replace the scraper (see the section
entitled Replacing the Scraper).
24