E N G L I S H
VACUUM CLEANER ASM582T
Important
Read these OPERATING INSTRUCTIONS
and the attached GENERAL SAFETY
INSTRUCTIONS LEAFLET carefully before
using the machine. Make sure you have
understood them before operating the
machine for the first time.
Keep both sets of instructions for any
future queries.
Read carefully the GENERAL SAFETY INS-
TRUCTIONS LEAFLET, which is included
in the machine documentation.
Before connecting the vacuum cleaner to
the mains ensure that the voltage is the
same as that on the vacuum cleaner.
Before connecting the power tool to the
vacuum cleaner, ensure the voltage of
the vacuum cleaner is the same as that
for the tool.
1. SPECIFICATIONS
Power..............................................................................1,400 W
Airflow...............................................................215 m
Water lift.............................................................2400 mm H
Tank capacity..................................................................21l
Connected power through socket.................2000 W max
Weight..................................................................................12 kg
2. DESCRIPTION
1 – Polyester filter to be placed in the tank during dust
collection.
2 – Class "M" cartridge filter.
3 – Suction inlet. (Suction nozzle).
4 – Flexible hose.
5 – Power tool socket.
6 – Switch.
7 – Clamps to fix the engine block to the tank.
3. PLANNED USE
The ASM582T vacuum cleaner can be used for all types
of dust, shavings and non-hazardous dirt. Its class "M"
classification indicates that it is suitable for collecting
mineral and wood dust with MAK values of >0.1 mg/m
The use of the vacuum cleaner also creates a healthier
working environment.
To achieve maximum vacuum cleaner
efficiency, filters should be cleaned
after each use.
4. OPTIONAL ACCESSORIES
8245847-Dust collector kit ASC682-ASM582T
8299645 Paper filter bag for ASM582T
8299656-Connection Y for ASM582T
6446073- 2.25 m standard suction connection.
USE OF PAPER FILTER BAG
Only use the dust collection bag with the filter car-
tridge fitted.
The bag ensures the recovery of the vacuumed dust in
hygienic conditions.
Vacuuming of sharp or damp materials may damage
the dust collection bag.
Change the bag when the material collected reaches
two-thirds of total capacity.
The bag cannot be reused and must always be replaced.
5. PREPARING AND TURNING ON THE VACUUM
CLEANER
5.1 ELECTRICAL CONNECTION
The service voltage shown on the charac-
teristics plate of the vacuum cleaner must
be the same as the power supply voltage.
/h
3
Before plugging the machine into the
O
mains, ensure that the switch is in the
2
(central position "0" of switch F) (Fig. 4).
5.2 ON/OFF SWITCH
This machine has a switch with three positions: "AUTO",
"0" and "MANUAL" F (Fig. 4).
In position "0", the vacuum cleaner is off.
"MANUAL" position
The vacuum cleaner turns on immediately. There is also
power to the machine's socket box.
"AUTO" position
On selecting the "AUTO" position, the machine automa-
tically shakes to clean the filter and the machine's socket
E (Fig. 4) provides power. The vacuum cleaner switches
on when the tool connected to this socket is turned
on. When the tool is turned off, the vacuum cleaner
continues to run for 10 seconds to clear the dust from
the tubes and it automatically shakes to clean the filter.
.
3
5