Publicité
Les langues disponibles
Les langues disponibles
Anleitung E-HS 660_SPK7:Anleitung HS 580 SPK 1
GB
b
Since the blades cut on both sides and run in
opposite directions to each other, you can trim in
both directions (see Fig. 6).
b
To achieve a hedge with a uniform height it is
recommended that you stretch a piece of string
along the edge of the hedge for guidance. Then
simply cut away all twigs projecting above the
line (see Fig. 7).
b
The sides of the hedge should be trimmed with
arc-type movements from below upwards (see
Fig. 8).
b
Operation with the trimmings collector (Fig.
13/14)
For horizontal trimming it is recommended that
you attach the trimmings collector. This enables
the trimmings to be removed more easily,
keeping the surface of the hedge tidier in the pro-
cess.
8. Care, maintenance and storage
Always switch off the machine and pull the plug
b
before you start to clean the machine.
b
For optimum results at all times you should regu-
larly clean and lubricate the blades. Remove any
deposits with a brush and apply a light film of oil
(see Fig. 9).
Use biologically degradable oil.
b
Clean the plastic body with gentle domestic clea-
ning agent and a damp cloth. Never use aggres-
sive media or solvents.
b
It is imperative that you prevent water from pene-
trating the machine. Never spray the machine
down with water.
b
For storage purposes the hedge trimmer can be
fastened to the wall with suitable screws and
dowels (see Fig. 10).
9. Faults
b
The machine does not start: Check that the
power cable is correctly connected and check the
mains fuses. If the machine still does not work
even with connected voltage, please send it to
the specified customer services address.
14
12.12.2007
10. Disposal
Important!
The hedge trimmer and its accessories are made of a
diversity of materials such as, e.g. metal and plastic.
Defective parts must be disposed of as special
waste. Ask your specialist dealer or local authority for
details about where they can be disposed of!
11. Ordering replacement parts
Please quote the following data when ordering repla-
cement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
15:41 Uhr
Seite 14
Publicité
