Installations On Hydraulic Front Mounting Pumps - Ultraflex PADDLE TRIM Manuel D'installation

Installation on hydraulic front mounting pumps
1
Pass the control device electrical cable through the hole provided in the half-bracket (10)
beforehand. Attach the control device (11) on top of the mounting half-bracket with the M4 screws
(12) and nuts (13) with a torque of 3 Nm (2.21 lbft).
For applications with dual command, repeat the procedure on the second device.
2
Before attaching the bracket to the steering system the surface that will be in contact
with the bracket should be thoroughly degreased. The mounting bracket can be installed in any
position as long as it is on the cylindrical surface of the steering system (14).
11
10
Installation Manual
12
13
14
PADDLE TRIM
15
- page