ergoline Ambition 200 Instructions D'utilisation page 51

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Presets
To change the keylock configuration:
– Press Reset once and then release it. The display will begin to flash.
– Press
unitl the desired option (00 to 03) is displayed.
– Press Reset once then release it.
– Next cycle the power to the timer and tanning device off and back on.
The keylock configuration is now saved.
– Press
to go to Parameter 26 (P26).
P26 – Third Party Interface
Parameter 26 is the Third Party Interface (TPI) Mode toggle. The timer
has a TPI jack built in to the timer itself. This jack replaces the need for a
second or additional interface when using other timer systems. The TPI
jack is located next to the two network jacks on the top of the tanning unit
(under the hinge cover). It is the larger of the three jacks and comes with
a unused modular plug in the jack. When using the Intellitan Plus timer in
TPI mode the Intellitan Plus looks for control voltage (5-30V) on the out-
side two wires of the modular cable plugged into the TPI port. When this
voltage is seen, the maximum tanning time is sent to the timer and the
tanning unit is started. Any session delay should be programmed on the
third party timer and the Intellitan session delay should be set to 0. The
front rail keys are locked in TPI mode.
When parameter 26 is shown, the display will read 0000 for disabled.
– Press
to go to 27 without changing the setting.
To enable TPI mode:
– Press Reset once and then release it. The display will begin to flash.
– Press
until 0001 is displayed.
– Press Reset once then release it.
– Next cycle the power to the timer and tanning device off and back on.
The TPI mode is now enabled.
To disable this function change parameter 26 back to 0000.
– Press
to go to Parameter 27 (P27).
P27 – Timer Protocol Option
The timer protocol option allows the studio operator to change timer
network protocols from the Intellitan protocol to the T-Max
use with the Applied Digital T-Max Manager. For additional information
please consult the T-Max documentation.
The options are:
0 – Intellitan remote.
1 – T-Max protocol.
1. T-Max is a registered trademark of Salon Systems, Inc./Applied Digital,
Inc. Branson, MO.
1
protocol for
51

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Ambition 250 vhp 20

Table des Matières