ergoline Ambition 200 Instructions D'utilisation page 44

Presets
Presets
To change parameters
To enter the System's data bank, monitor operations and verify the vital
functions concerning your unit, use the following step-by-step instruc-
tions.
Your tanning unit can easily be adapted for front desk and/or remote ope-
ration. Contact Global Service Division (see page 3) or your factory re-
presentative for more information on the Intellitan series of bed
controllers.
To enter the system:
– See password clearance (P01) on page 45.
To exit the system:
– Press Stop key until you reach 00:00.
– Start again with password clearance (P01).
To view the current parameter (if display is not flashing):
– Press key. Parameter will be immediately displayed.
If the display is flashing, you cannot check parameters!
44
Note:
Before changing any parameters the tanning unit must be
disconnected from the timer network for at least thirty (30)
seconds before the keys will unlock. Be sure to reconnect
the timer network after completing any programming. This
keylock configuration can be changed through parameter
25.