HEATSTRIP Design THH1500AEU Manuel D'utilisation, D'installation Et D'entretien page 17

Installation instructions
Ensure all minimum clearance requirements are met and the materials used
are compliant to your local building codes.
Before installing the Flush Mount Enclosure, ensure the site to be fixed is
fully prepared with the hole cut the correct size and the mounting points se-
curely in place.
STEP 1: Attach the brackets to the
rear of the heater. The dimensions
for the spacing of the brackets is
listed in the table.
STEP 2: Screw the Flush Mount
Enclosure into the side of the hole.
NOTE: screws are not included.
STEP 3: If there is no roof access,
connect the heater to the power
source, ensure the power is OFF.
STEP 4: Lift the heater into the
Flush Mount Enclosure ensuring
the brackets are to the side of the
mounts
STEP 5: Push the heater to the left
ensuring the brackets engage in the
mounts. It will then drop in. Shake
the heater to ensure that it is se-
curely mounted.
R A D I A N T
"D"
SIDE OF HOLE
SCREWS, AT EACH END, THERE ARE 6 HOLES
WITH A DIAMETER OF 8mm EACH
ON
OFF
O U T D O O R
MODEL
DISTANCE FROM END
TO BRACKET (mm)
THH1500AEU
THH2400AEU
THH3200AEU
HEATER
FLUSH MOUNT ENCLOSURE
H E A T E R S
"D"
150
370
425
BRACKET x2
"D"
17