Clarion OHM888VD Manuel De L'utilisateur page 25

3. If the vehicle's power supply requires negative polarity, slide this switch to the negative
(-) position. Otherwise, slide this switch to the positive (+) position.
Make sure the switch is fully to one side or the other. Do not
attempt to configure this switch once the player is in
position.
4. Cut a one-inch hole in the headliner along the backside of the ceiling bracket for the
cables to pass through.
Install the ceiling bracket and cables
1. Disconnect and remove the original dome light.
2. Screw the metal mounting plate to the beam or plywood using the six ST4.2 x 16
screws.
Note:
Do not cover the original dome light opening.
Connect cables
1. Pull out the original dome light's power wire and signal/power cable through the
original dome light opening.
2. Place the rubber gasket on the player.
3. Route the cables through the hole to the location of any audio/video sources.
4. Identify the dome light wires in the vehicle and connect them to the corresponding
OHM888VD / OHM1088VD / OHM1588VD
All manuals and user guides at all-guides.com
9 Polarity switch
Please slide to "-" at the left position
if your vehicle's power supply system is
negative. Please slide to "+" at the right
position if your vehicle's power sypply
system is positive
Notes: 1 Please slide it to a side fully.
2. Do not slide this swith after Place it
at a position. Otherwise, it'll be damage
Back of the player
CAUTION
Metal mounting plate showing screw positions
Placing the rubber gasket on the player
25