Place the burner cover on the table top as shown in Figure13.
WARNING: BEFORE PLACING THE BURNER COVER ON, MAKE
SURE THE FIREPIT HAS BEEN SHUT OFF AND THE BURNER
HAS COMPLETELY COOLED DOWN.
TROUBLESHOOTING GUIDE
PROBLEM
Burner won't light
Burner won't stay
lit after lighting
Our goods come with guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure and for compensation
for any other reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.
BURNER COVER ASSEMBLY
CAUSE
No Propane Gas at Burner
No Spark at Electrode
Lack of oxygen
Thermocouple not in flame
Thermocouple connection
at the main control valve is
loose
No Fire Ice on Burner
Figure 13
REMEDY
Check that gas tank valve is open. Turn
control knob to "ON" and push control knob
in. Make sure tank has propane gas.
Check that AA battery is installed with
negative (-) end first and has a charge.
Check that the wire is connected to the
ignition module. Check that the electrode is
not cracked or broken.
Remove excess lava rocks or fire ice from
around the ignition well.
Check that the tip of the thermocouple is
even with the top of the ignition well.
Remove any fire ice from the ignition well.
Tighten the thermocouple nut at the back of
the valve.
Cover the burner with fire ice per the
instructions.
12