Figure 4
4. After making any necessary adjustments to the alignment of the firepit, use the hex bolt
driver to tighten all bolts. Repeat until all bolts are tight. Do not over tighten. Over tightening
may strip bolts. With the help of another person, turn the table in the upright position.
5. Place the burner pan protective ring into the firepan/burner assembly as shown in Figure 5.
Align the holes in the burner pan protective ring with the pre-drilled holes on the firepan/burner
assembly. Secure the burner pan protective ring to the firepan/burner assembly by using the
two M4 screws as shown in Figure 5.
Figure 5
6. Pour the fire ice into the burner pan completely covering the burner. The weight of the fire
ice is (7kg plus and minus 10%). Remove any fire ice on top of the ignition well. See Figure 6.
Figure 6
7